fuyangby@126.com
86 15188770013
fuyangby@126.com
86 15188770013
Key points for assembly of mud pump
The assembly of mud pumps is a meticulous and technically demanding process, and the following are some key points of mud pump assembly:
Check for defects in each part: Before assembly, it is necessary to carefully inspect each component for defects to ensure that only intact parts are used.
Lubrication of bearings and seals: Add two-thirds of butter to the bearings, apply a thin layer of butter on both sides of the paper pad, install the O-ring into the shaft sleeve, apply butter, add butter to the skeleton oil seal, place it in the mud pump seat, and then install the bearings.
Installation of bearings and shafts: Install the bearings on the motor base, then place paper pads and oil blocking rings, and fix the shaft and support tube with screws.
Installation of pump seat and impeller: Place the bearing, shaft sleeve, key, pump seat, and impeller on a paper pad, tighten the impeller nut, and manually rotate the impeller to make it flexible.
Installation of pump casing and filter: Install the key and driven coupling on the pump shaft, install the key and active coupling on the motor shaft, and then fix the motor on the motor base with bolts. Place the paper pad on the mud pump casing, secure it with screws, and then install the filter.
Pre operation inspection: Before running the pump, check whether the inlet and outlet pipes are blocked and whether the front and rear bearings are lubricated.
Reference for slurry pump
There are many similarities in structure and function between slurry pumps and mud pumps, so the assembly points of mud pumps can be referenced when assembling slurry pumps. Slurry pumps are usually used in more harsh working environments, such as pumping slurry containing a large amount of solid particles, so special attention should be paid to wear resistance and sealing requirements during assembly.
Selection of wear-resistant materials: As slurry pumps need to handle slurry containing abrasive solid particles, wear-resistant materials such as high chromium alloy cast steel are usually used for the pump body and impeller to extend their service life.
Selection of seals: Slurry pumps may use double end mechanical seals, series three way assembly, and hard alloy materials. This design can improve wear resistance and sealing effect.
Attention to assembly details: When assembling slurry pumps, it is also necessary to pay attention to the lubrication of bearings and seals, as well as the correct installation of pump casings and filters. In addition, it is necessary to check whether the inlet and outlet pipes are blocked and whether the front and rear bearings are filled with grease.
By referring to the assembly points of mud pumps, the assembly quality and operational reliability of slurry pumps can be ensured, thereby achieving better performance in practical work.
This article originates from https://www.fuyangpumps.com/news/399.html. Please indicate the source when reprinting.
(Editor in charge: Slurry Pump https://www.fuyangpumps.com/)
Copyright © Hebei Fuyang Pump Industry Co., Ltd.
